IPv4 Address: 192.168.2.20Īfter making the necessary settings, use the PC0’s Command Prompt tool to ping the Router’s GigabitEthernet0/1 and GigabitEthernet0/2 interfaces as well as PC1 on the other network and test the network connection. Since PC1 is in the network connected to the other interface of the Router, you need to assign an address from IP block 192.168.2.0/24. After clicking on PC0, click on IP Configuration in the panel that opens, and assign the IP address 192.168.1.10.

To assign static IP addresses to PCs on the network, you must use the IP Configuration interface on the Desktop tab. Router(config)# interface gigabitEthernet 0/2 Router(config)# interface gigabitEthernet 0/1 Then, execute the commands below in the CLI command prompt to assign IP addresses to the router’s interfaces and activate the ports. Likewise, wire the Switches and PCs connected to the other GigabitEthernet interface of the Router as in the image below. Ip dhcp excluded-address 172.31.40.1 172.31.40.Since the network connection between the Switch and the Router must be fast, connect one end of the cable to the GigabitEthernet 0/1 interface of the Switch and the other end to the GigabitEthernet 0/1 interface of the Router. Verify all devices can now ping each other and Scripts.Configure R1 as a DHCP client so that it receives an IP address from the ISP network.Click Fast Forward Time to speed up the process. Note: DHCP address assignments may take some time. Verify that each PC has an address assigned from the correct DHCP pool.Prevent the first 10 addresses from each pool from being distributed to end devices.Configure the DNS server 209.165.201.14 for each pool.Configure DHCP to provide the default gateway address.Assign the appropriate addresses to each pool.Configure R1 to act as a DHCP server for the VLANs attached to S2.

Subinterface names should match the VLAN number.

Configure all non-trunk ports on S2 as access ports.

Create VLANs on S2 and assign VLANs to appropriate ports.

Using the information in the tables above, implement the following requirements: In this culminating activity, you will configure VLANs, trunks, DHCP Server, DHCP relay agents, and configure a router as a DHCP client. Topology Addressing Table VLAN Port Assignments and DHCP Information Scenario Instructor Note: Red font color or Gray highlights indicate text that appears in the Answer copy only. Packet Tracer – Skills Integration Challenge ( Instructor Version)

Cisco packet tracer 8.3.1.2